Security Ranger III Guía de usuario descargar pdf (Pagina 75)

Performing an IR Quick Read

NOT: N An IR read must be performed before any other function can be used.

1. Connect the IR cable to the nine-pin serial port on

the bottom of the handheld.

2. Align the optical read head of the IR cable with the

endpoint IR port.

3. Tap Read.

Result: The screen lls with endpoint information and

the programming buttons become active.

Figure 132: ORION CE IR Quick Read screen

Start, Pause, Stop - Radio Modes

All ORION CE endpoints are programmed at the factory to begin sending meter readings as soon as the register senses flow

through the meter. As a result, ORION CE endpoints can be installed on meters without having to manually start the endpoint.

When usage is registered on the meter, the endpoint sends a signal every four seconds.

The Start button is used to start an endpoint before usage

is registered. Align the optical head on the IR cable with the

endpoint IR port and tap Start.

The Pause button is used to pause the radio signal

temporarily. Align the optical head on the IR cable with

the endpoint IR port and tap Pause. The endpoint begins

transmitting again when usage is registered from the

meter.

Figure 133: Radio modes

The Stop button is used to stop an endpoint from sending a signal, regardless of the usage registered from the meter. Align

the optical head on the IR cable with the endpoint IR port and tap Stop. The Start button must be used to turn the endpoint

on again.

NOT: N Stopped radios must be restarted using the Start function (above) and will not automatically restart when usage

is registered from the meter. When used with an RTR, the odometer value must also be programmed to reflect the

current registration reading. Refer to "Programming an ORION CE Endpoint" onpage76 for more information.

When used with an ADE, the odometer value is automatically updated within the hour.

Installation & Operation Manual

Page 75 February 2013

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 123 124

Sin comentarios

Security Ranger III Guía de usuario Pagina 75