Security Ranger III Guía de usuario descargar pdf (Pagina 23)

Historical Data

Whether initiated automatically or manually, the ORION field application software is capable of extracting historical profile

data from an ORION ME endpoint at the following intervals:

7 days (Week) 14 days (Two weeks) 30 days (One month) 60 days (Two months) All readings stored in the endpoint

(Shorter months include extra days of readings, up to 30) (Up to 90 days of hourly readings or 2160 reads)

This chart shows the number of readings collected for meters set at 60 minute (hourly) intervals and at 15 minute (quarter

hourly) intervals:

Available Prole Data

Extraction Intervals

Hourly Reads:

1 Read per Hour

24 Reads per Day

15 Minute Reads:

4 Reads per Hour

96 Reads per Day

7 days 168 reads (24 x 7) 672 (96 x 7)

14 days 336 reads (24 x 14) 1344 (96 x 14)

30 days 720 reads (24 x 30) 2160 (96 x 22.5)

60 days 1440 reads (24 x 60) 2160 (96 x 22.5)

All/ 90 days 2160 reads (24 x 90) 2160 reads (96 x 22.5)

NOT: N The ORION ME endpoint (or SE in mobile mode) is capable of holding up to 90 days of hourly interval data, or 2160

hourly reads. If the account is set up to read every 15 minutes – 4 readings per hour – the data extracted reflects four

(4) readings per hour and reaches the maximum 2160 reads in 22.5 days (90 days / 4 = 22.5 days).

Requesting Historical Data Manually

If a work item was not assigned by the reading data management operator, you can manually initiate a request for the

historical interval data from the current ORION ME or SE (mobile mode) endpoint by performing the following steps.

1. Tap the ORION ME Details button on the account

read screen for an ORION ME account.

Result: The ORION ME Details screen opens with the

Historical tab selected as shown in Figure 27.

NOT: N If a work item is set to be performed

automatically, the message says "Required"

and the selection buttons are inaccessible

(grayed out).

Figure 27: Historical data tab

2. Tap one of the buttons to select the number of days of historical data to collect: 7, 14, 30, 60 or All.

3. If the Test Circle Selection screens display, select the appropriate unit of measure for the meter:

Tap the unit of measure (cubic feet, gallons, cubic meters) and then select the registration and reading resolution

from the available list for the selected meter. Use the scroll bar to navigate through the list. Examples of these screens

are shown in Figures 28 and 29 on the next page.

Installation & Operation Manual

Page 23 February 2013

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 123 124

Sin comentarios

Security Ranger III Guía de usuario Pagina 23