Security Ranger III Guía de usuario descargar pdf (Pagina 67)

RF Extraction

To access profile data for an ORION ME or SE (in mobile mode) endpoint using RF, follow these steps.

1. Tap the IR/RF box so RF displays.

2. Tap in the S/N eld and use the handheld keypad or the barcode scanner to enter the serial number of the endpoint.

NOT: N Refer to "Barcode Scanner" onpage97 for instructions on setting up the scanner for use.

3. Tap Read Endpoint.

Result: The Read Endpoint button disappears and the screen displays "Waiting for Mobile Message" as shown in Figure

114. When the Mobile Message is heard, the Get Data button becomes active as shown in Figure 115.

Figure 114: RF Profile Waiting for Mobile Message

Figure 115: RF Profile - Mobile Message received

Tap Get Data.

Result: Three status messages display - one at a time:

• Waiting for Mobile Configuration

• Waiting for Extended Status

• Waiting for Profile Data

After the last message, the profile data for the endpoint

is extracted. The screen fills as shown in Figure 116.

4. Tap Save to save the le to the handheld.

Result: The Test Circle selection screen displays.

5. Tap to select the Test Circle Code for the encoder.

Figure 116: Profile data extracted

Result: The file is saved to the handheld with the serial number and the date and time of the save in the file name. The

Interval Data Saved confirmation screen displays as shown in the example in Figure 113.

6. Tap Ok to close the Interval Data Saved screen.

NOT:N Historical profile data is also available during route reading. Refer to "Requesting Historical Data Manually"

onpage23.

Installation & Operation Manual

Page 67 February 2013

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 123 124

Sin comentarios

Security Ranger III Guía de usuario Pagina 67