Security Ranger III Guía de usuario descargar pdf (Pagina 55)

ADE Extended Status

Figure 91: Extended Status - ADE

The status indicators described below apply for an ORION ME or SE (mobile mode) endpoint when connected to an

ADE encoder.

Status Indicator Description

Mobile Mode Endpoint is communicating in mobile transmission mode.

IR Programmed Endpoint has been reprogrammed via IR.

Low Battery Endpoint is reporting a low battery condition.

Tamper Endpoint is reporting a tamper condition. This condition occurs when the wire between the register

and the endpoint is cut or shorted, or the encoder is not connected.

Encoder Error Device error reported by the endpoint when the encoder exhibits a temporary or permanent failure

to extract the current reading.

No Usage Endpoint is reporting a no usage condition. This condition occurs when there is no water flow

registered over a 30-day time frame.

Leak Endpoint is reporting a potential leak condition when there is continuous usage over a 24-hour time

period without a 2-hour period of non-usage.

Reverse Flow Encoder is reporting a reverse flow condition to the endpoint.

Encoder Information Description

Size & Type The size and type of the meter for which the encoder was programmed. Tap the button to change

the meter size and type.

Units The units of measure as defined by the encoder: cubic meters, cubic feet, gallons, imperial gallons or

liters. Tap the button to change the units.

Encoder The encoder protocol.

Dials The encoder dial resolution (4-, 5- or 6-dials) as reported from the encoder.

NOT: N Refer to the ORION Water Endpoint Technical Brief, ORI-T-58-EN, for complete information.

Installation & Operation Manual

Page 55 February 2013

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 123 124

Sin comentarios

Security Ranger III Guía de usuario Pagina 55