Security Ranger III Guía de usuario descargar pdf (Pagina 74)

ORION CE IR Programming

The ORION CE IR Programming screen is used to start, stop and pause ORION CE endpoints as well as program an ORION CE

endpoint following a tamper repair or retrofit installation (RTR installations only).

NOT: N An ORION endpoint connected to an ADE (or approved competitive three-wire encoder) does not require

programming to clear a tamper. After the wires have been repaired, the endpoint is automatically updated to reflect

the register odometer value in the first hour after the wires have been repaired.

NOT: N For instructions on programming a gas endpoint, refer to "Programming an ORION CE Gas Endpoint" onpage81.

The buttons and fields on the ORION CE IR Programming screen are described below. An example of the screen is shown in

Figure 132 on the next page.

IR Programming Buttons

Read Read the endpoint using the IR programming cable.

Program /

Force Read

When used with an RTR encoder, Program is used to set the endpoint odometer value following a tamper

repair. When used with an ADE encoder, Force Read is used to view the real-time encoder odometer value.

Stop Stop the endpoint from sending a transmission. Stopped endpoints must be re-programmed to begin

transmitting again.

Pause Pause the endpoint transmission temporarily until a unit of water or gas is registered. (Common practice of

seasonal users.)

Start Start the endpoint radio transmission.

HPwr Force a brief high powered signal from the endpoint to an ORION CE gateway receiver.

Listen Switch to RF to "hear" if the endpoint is active.

IR Programming Buttons - Gas Endpoint Only

Drive Circle? Displays after initial read for gas endpoints only. Provides access to a read-only screen displaying the

possible drive circles for the gas endpoint.

Change DC Displays after initial read for gas endpoints only. Used to select the gas drive circle information.

IR Programming Display Fields

Serial # Displays the serial number of the ORION CE endpoint.

Reading Used to view the current endpoint reading value. For an RTR, it is used in conjunction with the Program

button to reprogram the odometer value after a tamper repair.

Status Displays the endpoint status which provides information regarding the programming and configuration of

the endpoint.

Radio Used to view the endpoint radio transmission mode.

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 74 February 2013

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 123 124

Sin comentarios

Security Ranger III Guía de usuario Pagina 74